PrintaClean printbed cleaner - AprintaPro - 250ml

Sometimes 3D prints and adhesives can leave nasty residue on the build plate. PrintaClean is a powerful solvent to effectively remove this sticky residue from the build plate with ease so the next creation can start on a clean slate. The 250ml last for a lot of clean ups.

Instructions

Make sure to spray only a build plate that has cooled off. Then remove the build plate from the 3D printer and spray a good amount of solution on it. Let the solution sit for 20-30 seconds to loosen the residue. Wipe off with a paper towel. Repeat if necessary or allow for a longer exposure time.

Hazard and precautionary statements

Danger: If medical advice is needed, have product container or label at hand. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. If eye irritation persists: Get medical advice/attention. Dispose of container safely. Highly flammable liquid and vapor. Causes serious eye irritation. May cause drowsiness or dizziness.