Ingen varer
Priserne er inklusiv moms
En rulle med høj kvalitets nFEP film fra PrimaCreator
PrimaCreator nFEP er fremstillet af højkvalitetsmateriale som tillader en høj lys gennemtrængning og god pålidelighed. For at beskytte filmen imod klem og ridser, er hvert ark beskyttet med en film på begge sider og er pakket i et meget kraftigt paprør.
Denne rulle kan skæres til, så den passer til enhver 3D DLP printer.
Eksempler på printer den passer til er: Anycubic Photon og Photon S samt Mono serien (Mono, Mono SE og Mono X), Creality LD-002R/002H og Wanhao GR1, samt en lang rækken Phrozen og Elegoo printere.
På lager online & butik
Advarsel: Sidste enheder på lager!
Tilgængelighedsdato:
28009
Roll of high quality PrimaCreator nFEP film.
PrimaCreator nFEP combines the properties of FEP and PTFE, which gives you the ultimate non-stick surface. This reduces the risk that your objects get ripped off from the build plate and getting stuck in the tank. This is how nFEP reduces the risk of failed prints.
Since objects are less likley to stick to the film, less force is required to lift the build plate on each curing cycle, causing less strain on the motor in your printer. It also causes less strain and less ben bending motions on the nFEP sheet itself, making it last longer before wearing out.
nFEP is also smoother then regular FEP, to make sure you get the best print quality possible.
PrimaCreator nFEP film sheets are made of high quality material to ensure high light transmittance and good reliability. To protect the sheet from wrinkles and scratches, each sheet comes with a protective film on both sides and are packaged in a sturdy cardboard tube.
This nFEP sheet can easily be cut to fit almost any 3D-printer.
One roll (30x160cm) is enough for:
Please remove the protective film from both sides of the nFEP sheet before use.
Spare Parts Category | RESIN TANK |