Ingen varer
Priserne er inklusiv moms
Varen er nu lagt i din kurv
Der er 0 varer i din kurv Der er 1 vare i din kurv
Bondtech opgraderingsekstruder til RAISE3D DualDirect med dobbelte dyser. Dette sæt giver et højtydende materialefremføringssystem med mulighed for at printe hurtigere med forbedret kvalitet. Den justerbare fingerskrue giver dig mulighed for at finjustere kraften, der virker på filamentet. Husdelene er professionelt SLS-trykt i polyamid for maksimal styrke og præcision. Bemærk venligst! På tidlige printere kræves et adapterkabel for at forbinde fabrikskablet til den nye motor.
Du kan afgøre, om din printer har ældre motorer med en nem visuel kontrol. Motorer, der kræver en adapter, vil have et sølvfarvet udseende (umalet aluminiumsfinish) på for- og bagsiden af motoren. Hvis motorerne på din printer har en sort motorendeplade foran og bagpå, har du ikke brug for denne adapter.
På Fjernlager
22479
This extruder upgrade kit for the Raise3D N1/N2/N2+ printer will replace the original feeder placed on the printhead.
It allows for a more reliable printing with all sorts of filaments, both stiff and flexibles and the DualDrive system ensures that the extruder never looses grip of the filament so grinding, slipping is a thing of the past.
Original extruder setup on Raise3D is 890g for dual setup, this new upgrade is 425g with the included motors and it allows for faster printing without surface issues due to vibration during accelerations/deaccelerations.
The kit comes with it owns lightweight pancake motoThe extruder is equipped with two push-fit connectors for 4 mm guide tube that will let you connect the existing guide tubes to the extruder. Tubes are not included.
Installs in about half an hour with standard tools available.
This upgrade fits both the Revision 1 (casted) and Revision 2(cnc-milled) version of the printhead.
Full installation guide available at the tab installation guide.
Installation is done in about 20 minutes.
Plug & Play solution, no need to cut and solder wires.
E-step value: 415
IMPORTANT!!
It has come to our knowledge that if the ribbon cable to the break-out board gets unplugged when the printer is turned on, thermal runway might happen, make sure that the ribbon cable is securly held in place with hotmelt or a zip tie.
